How to connect DIYHFS & DIYHS

Technical support for DiyHiFiSupply kits and products. Got a problem then ask here.

How to connect DIYHFS & DIYHS

Postby Florus » Thu Oct 16, 2008 2:51 pm

How do you connect the Ultra low noise filament supply en de active bias supply module together on a push pull 300B amp?
In Short terms what is the correct way?
Can i just connect the filament supply to the tube and put 10 Ohms from one end of the filament (Cathode) to ground and measure over that resistor?

Is it possible to use one filament supply for 2 tubes?
Florus
 
Posts: 1
Joined: Thu Oct 16, 2008 2:23 pm

Re: How to connect DIYHFS & DIYHS

Postby brian » Mon Oct 20, 2008 3:31 am

You can connect it just as the attached schema shows. I think it would be better to use a pair of the filament supplies because running two 300 B. filaments from one supply would be right at the limit and would require an awful lot of heat sinking.
http://www.diyhifisupply.com/?q=node/404
Image
brian
Regular Admin
 
Posts: 103
Joined: Wed Sep 24, 2008 4:58 am


Return to Technical Support

Who is online

Users browsing this forum: No registered users and 1 guest

cron