Page 1 of 1

universal tube output stage

PostPosted: Wed May 13, 2009 6:53 pm
by devas
The UTOS has worked a while in my SATCH, I have made an output stage of my own for the Satch and decided then to connect the UTOS to a Lampucera DAC (cs4398) abiding to the installation manual settings of the jumpers for cs4398 (output from voltage output, 3.14) but it yields no sound at all, I checked several times the settings and everything is correct. Any tips ?
The dac works normally with the opa's...

Re: universal tube output stage

PostPosted: Wed May 20, 2009 10:11 am
by brian
Can you put the UTS back in the original DAC and check if there is output? If configured correctly it must pass signal if there is signal at teh inputs.

Brian

Re: universal tube output stage

PostPosted: Sat May 23, 2009 6:03 pm
by devas
Yes it does work back in the Satch...